20
Programming by the day
9.4 - Select MANUAL operating mode and then set
the desired temperature using the rotary control
(fig. 30).
9.5 - Press the button twice (fig. 31).
In place of the current time d01 will appear.
9.6 - Press the or buttons (fig. 32) until the
desired number of days is reached from 1 to 99.
The days count includes those when programming
is performed. The remaining part of the day when
the operation is performed is therefore counted as
one day.
before the programmed period expires press the
button (fig. 29).
Fig. 28
To Next Page
Loading...
