28
The delay can be programmed for several different
hours during the same day.
15 - REMOTE CONTROL
Connecting an appropriate interface to terminal
block connections 1-2 (fig. 8 or 9) it is possible to
remotely active a special pre-defined SHORT
TERM MANUAL PROGRAMME. Whenever the
manual short term program is activated remotely,
as long as no other operations are performed then
when the program reaches its conclusion THER-
MOPROGRAM will go back to the status it was in
prior to activation. To cancel remote control of the
fixed-time manual program press the button.
The predefined running time for the short term pro-
gramme is 1 hour at 20°C
Note. When the program is activated remotely
the time remaining within the hour or day will be
counted as a full hour or day.
Fixed-time manual programming by remote
control
15.1- Make sure that the unit is in MANUAL oper-
ating mode.
15.2 - Use the rotary control to set the temper-
ature (fig. 47).
15.3- Press button once to set the hour (fig.
48), twice to set the days applicable (fig. 49).
If the hours are being set then instead of the cur-
rent time h01 will appear on the display. If the days
are being set then d01 will appear.
Fig. 47
To Next Page
Loading...
