Installation
16
Sleeving Material
Sleeving material is processed the same way as labels. If the material is
Brady-brand IP enabled, the printer will display the gap sensor switch setting
on the LCD display. This is true for only IP-enabled material (not compatible).
Refer to Gap Sensors on page 17. Set the gap sensor switch to the setting
displayed and the printer will operate in Brady mode. Refer to Brady Mode on
page 14.
If the material is not Brady-brand, the printer will operate in Standard mode.
Refer to Standard Mode on page 16.
Custom Material
Custom Brady material is processed in Hassle-free mode.
Standard Mode
If the printer is operated in Standard mode or with non-Brady software and the
user inserts Brady non-metallized label material, the printer will automatically
execute the basic functions of detecting heat setting, print speed and sensor
information. There is no way for the printer to determine label size. The user
will need to manually enter media print settings.
The LCD display shows:
■ The letter S in the top, left corner which indicates that the printer is
operating in Standard mode.
■ The online status of the printer.
Whenever possible, manually apply media print settings through the software.
To Next Page
Loading...
Need help?
General
