Control Panel
39
Status Print
The Status print function prints a test image containing information on the
configuration and status of the printer. The printout occurs using the heat level
and print speed specified in the Setup > Print param. menu.
NOTE: Continuous media is most suitable for this function.
1. Press the menu key.
2. Select Test > Status print menu.
3. Press the
key.
You can cancel the printout with the cancel key.
The printout contains the following information:
■ Device type
■ Version and creation date of the firmware
■ Version and creation date of the system loader (bootloader)
■ Current values of selected local settings (refer to Local Settings on
page 47)
■ Current values of selected device settings (refer to Device List on page 41)
■ Current values of selected print parameters (refer to Print Parameters on
page 50)
■ Current values of selected interface parameters (refer to Interfaces on
page 52)
■ Status of PIN activation (refer to Security on page 53)
■ Operation time
■ Number of labels printed
■ Printed length with thermal transfer printing and thermal direct printing
■ Current measured values of the printhead temperature and heat voltage
■ Information about the label sensor
■ Lines used to evaluate the print quality