Loading the Ribbon and Material
30
The printer is ready for operation when all connections are made and labels
and ribbon are loaded.
Synchronizing the Paper Feed
After the label stock has been inserted, the printer will calibrate automatically
if Brady IP enabled materials are used. If materials other than Brady IP
enabled are used, calibration is performed manually.
■ Select the material type in the software.
■ Press the feed key to start the synchronization.
■ Remove the blank labels produced during the synchronization.
A CAUTION
Printhead damage caused by improper handling!
• Do not touch the bottom of the printhead with
fingers or sharp objects.
• Ensure that the labels are clean.
• Ensure that the label surfaces are smooth. Rough
labels act like emery paper and reduce the
service life of the printhead.
Print with the lowest possible printhead
temperature.
To Next Page
Loading...
Need help?
General
