Breas iSleep 20+ - Using the iSleep 20+; Checking the iSleep 20+ before Use; Switching the iSleep 20+ On and Off

21Using the iSleep 20+
iSleep 20+ users manual
Doc. 004270 En-Eu T-3b
5 Using the iSleep 20+
5.1 Checking the iSleep 20+ before Use
Always make the following checks before using the iSleep 20+:
1 Connect a cleaned or a new patient circuit to the iSleep 20+.
2 Connect the iSleep 20+ to the mains supply.
3 Check patient settings.
4 Switch on the iSleep 20+ by pressing the Start/Stop button on the front
panel. Ensure that the iSleep 20+ is running.
5 Put on the mask and adjust its fit.
6 Ensure that the settings are adjusted as prescribed.
The iSleep 20+ is ready for use.
5.2 Switching the iSleep 20+ On and Off
The iSleep 20+ is connected to a power supply when the LCD display is lit up.
1 Make sure the power supply
is connected.
2 Turn on the iSleep 20+ by press-
ing the Start/Stop button on the
front panel for 2 seconds.
This operation switches the
iSleep 20+ between standby and
operating mode.