Breas iSleep 20+ - Connecting the iSleep 20+ to the Mains Supply

29Preparing the iSleep 20+ for Use
iSleep 20+ users manual
Doc. 004270 En-Eu T-3b
6.2 Placing the iSleep 20+
6.3 Connecting the iSleep 20+ to the Mains Supply
To Connect the iSleep 20+ to the Mains Supply:
Read the chapter “Environmental Conditions” on page 9 carefully to
make sure all conditions are fulfilled and considered.
1 Place the iSleep 20+ on a solid,
flat surface. The iSleep 20+ should
be placed lower than the patient in
order to prevent the device from fall-
ing on the user.
2 Make sure that nothing can block
the patient air inlet at the side of the
iSleep 20+.
Read the chapter “Electrical Safety” on page 8 carefully to make sure all
conditions are fulfilled and considered.
1 Plug the power supply into the
power inlet of the iSleep 20+.
2 Connect the power cord into the
power supply.