27
Step Mode Display
[ AIR ]
Air visibility mode
Air visibility is measured in distance (either in km or miles),
and is generally refer to the distance at which an object or light
can be clearly discerned, and it depends on the transparency
of the surrounding air. Visibility range can reach over 50km on
exceptionally clear day, down to under 1km on hazy day.
If the WI-FI connectivity is not stable for over 3 hours, the air
visibility will not be shown, and the
icon will disappear.
[ AIR ]
HCHO ( Formaldehyde ) mode
If you paired the HCHO / VOC optional sensor. The console can
display HCHO reading.
[ AIR ]
VOC ( Volatile organic compound ) mode
If you paired the HCHO / VOC optional sensor. The console can
display VOC level 1 ~ 5.
[ AIR ]
PM2.5/10 mode
If you paired the PM2.5/10 optional sensor. The console can
display PM2.5 /10 or relevant AQI reading.
The PM2.5 /10 sensor has default display in PM2.5. However, user
may press [ UNIT ] key to change readings in the following display
sequence: PM2.5
PM10 PM2.5 AQI PM10 AQI.
[ AIR ]
CO
2
mode
If you paired the CO optional sensor. The console can display CO
reading.
[ AIR ]
CO mode
If you paired the CO optional sensor. The console can display CO
reading.
4.3.17.1 ACTIVATE THE AUTO LOOP IN AIR QUALITY SECTION
To activate the auto-loop function in this section, just press and hold the [AIR] key for 2 seconds
and the
icon will show near the reading of the connected sensor(s) at 4 seconds interval.
NOTE:
- The PM2.5/10, HCHO/VOC, CO and CO sensor are optional sensors, which is not included.
4.3.18 SKY CONDITION
Sky condition section show the % of cloud cover according to the device location input in PWL. If
you have optional lightning sensor, you can also view the lightnings detected instantly.
To Next Page
Loading...
Need help?
General
