8
Step 2: Connect the Ni-MH rechargeable battery plug
to the socket.
Step 3: Make sure the red LED indicator on the back
every 12 seconds.
Step 4: Adjust the cable and socket into shallow hole
and put the battery pack into the battery compartment.
Step 5: Close the battery door and tighten the screw
NOTE:
- USE ONLY the rechargeable 3.6V Ni-MH battery-pack provided.
-
- It is recommendable to wrap water-resistant tape over the socket for extra protection against
moisture and salinity in air.
To Next Page
Loading...
Need help?
General
