www.bresser.de
3.2.4 Views
① Changing views
Change the model views by moving, rotating and scaling.
● Pulling
Click on the [View] icon. The object can then be moved using one of the
following three methods:
Method 1: Drag the mouse while holding down the left mouse button.
Method 2: Drag the mouse while holding down the middle mouse button.
Method 3: Drag while holding down the Shift key and right mouse button.
● Rotate
Click on the [View] icon. The object can then be rotated using one of the
following two methods:
Method 1: Hold down the right mouse button and drag.
Method 2: Hold down the Shift key and left mouse button and drag.
● Scaling
Turn the mouse wheel to enlarge or reduce the printing plate.
② Set the view
The user can view the object on the printing plate. There are six views available in the
View menu, i.e. the home view, the view from below, from above, from behind, from
the front, from the left and from the right.
Method 1: Click the [View] button. The drop-down list then lists six views.
Method 2: Click on the [View] button and then click again to open a submenu
with the six views available for selection.
③ Reset the view
There are the following two ways to reset views:
Method 1: Click the [View] menu and select [Home View].
Method 2: Click the [View] button on the left, and click it again to display the
display options. You may then click on [Reset].
To Next Page
Loading...
