36
5) Activate the Brigade Backsense
®
System (ensure the vehicle cannot move) and verify the
Status Light is illuminated constant green on the display within less than 7 seconds.
6) If the display shows any of the 5 Zone Lights activated, this indicates there are likely to be
one or more objects in the detection area interfering with the test. Move the vehicle to a
clear area and proceed.
7) Verify each detection zone’s distance: Starting from the outside of the detection area, the
operator should check several points along the centre line of the detection width down to
around 0.4m distance from the sensor. The display should show the detection alerts via
the lit Zone Lights, the buzzer pulsing speed and, if the trigger output is used, the
connected device or function. The operator should note down the distance at which each
detection zone is activated and if it is in line with the installed system or the configuration
for this vehicle.
8) Verify objects between 0.3m distance from the sensor and within Zone 1 are detected. All
zone lights should stay active while the object is in Zone 1.
9) Very close detection awareness: Verify objects less than 0.3m from the sensor are not
detected. All the Zone Lights and buzzer output should switch off after less than 3 seconds
with only the Status Light remaining illuminated constant green.
10) Similar to the previous tests, the operator should scan all the edges of the detection area
according to the installed system or configuration for this vehicle. They should note down
the detected locations and check if they match with the detection area set when this
Brigade Backsense
®
System was installed on this vehicle.
To Next Page
Loading...
