To Next PageTo Next Page
Need help?Do you have a question about the Briggs & Stratton 200000 HORIZONTAL SERIES and is the answer not in the manual?
General| Cylinder | Single |
|---|---|
| Cooling System | Air-cooled |
| Bore | 2.69 in (68.3 mm) |
| Fuel Type | Gasoline |
| Starting System | Recoil |
| Oil Capacity | 20 oz (0.6 L) |
| Ignition System | Magnetron electronic ignition |
| Shaft Orientation | Horizontal |
| Governor Type | Mechanical |
| Engine Type | 4-cycle |
| Stroke | 1.93 in (49 mm) |
Information on hazards associated with engines, risk of injury, and how to avoid them.
Details on fuel and oil recommendations, and general maintenance procedures.
Provides a schedule for regular maintenance tasks based on operating hours.
Procedures for adjusting engine components like remote controls and governors.
Step-by-step guide for adjusting the governor system for proper engine speed.
General approach to diagnosing engine operation problems by checking systems.
Procedure for testing the engine's ignition system for proper spark.
Guidance on checking carburetion, including fuel flow and common issues.
Instructions on how to check engine compression using a leakdown tester.
Details on testing electrical components like alternators and starters.
Diagnosing and testing electric starter systems and their components.
Information on battery requirements, installation, and charging procedures.
Instructions for removing, inspecting, and installing mufflers.
Guidance on inspecting exhaust system components for damage or wear.
General information and safety precautions related to fuel systems.
Instructions for draining, replacing, and inspecting the fuel filter.
Procedures for removing, inspecting, and installing fuel tanks and valves.
Overview of carburetor identification and service procedures.
Detailed service instructions for various carburetor types.
Service procedures specific to LMS carburetors.
Detailed procedures for servicing the governor system.
Procedures for servicing the cylinder head for various engine models.
Procedures for removing and servicing rewind starter assemblies.
Troubleshooting and service for electric starter systems.
Overview of the different types of lubrication systems used.
Procedures for inspecting, reconditioning, resizing, and cleaning cylinders.
Information on checking and replacing main bearings.
Procedures for removing, inspecting, and installing crankshafts and camshafts.
Procedures for disassembling, inspecting, and assembling gear reductions.
Information on Synchro-Balance® and AVS® counterbalance systems.
Steps for removing the piston and connecting rod assembly.
Guidelines for inspecting pistons, pins, rings, and connecting rods.
Steps for installing the piston and connecting rod assembly.
