10
Operation
IMPORTANT: This unit has been tested and sanitized prior to packing and shipping. During transit, dust and
odors can accumulate in the tank and lines. Dispense and dispose at least one quart of water prior
to drinking any water.
Turn the Dispenser On/O
IMPORTANT: Before you activate the hot and cold switches, ensure water has filled the tanks inside the
dispenser in order to prevent dry heating.
1. Plug in the dispenser and turn the On/Off switch to On.
2. Run water through the tap until water begins to dispense.
3. To power on the cooling system, ip the cooling switch on the back of the dispenser to the On position. The
cold water button on the front of the dispenser illuminates in blue indicating that the dispenser is cooling water.
The light turns off when the cooling process is complete.
4. To power on the heating system, ip the heating switch on the back of the dispenser to the On position. The hot
water button on the front of the dispenser illuminates in red indicating that the dispenser is heating water. The
light turns off when the heating process is complete.
Set the Clock
1. Press and hold the up and down arrow buttons for 3 seconds until the clock display begins to blink.
2. Press the cold water button to set the minute and the hot water button to set the hour. Use the up and down
arrow buttons to scroll until the correct minute/hour is displayed.
3. Press the hot water lock button when nished.
Set the Cold Temperature Setting
1. Press and hold the down arrow button for 3 seconds until the cold water button starts to blink and the current
cold water temperature appears on the display.
2. Use the up and down arrow buttons to scroll to your desired cold water temperature. The range is 39℉ to 59℉
(4˚C to 15˚C).
3. Press the lock button when nished. The temperature stops blinking and the time is displayed.
Set the Hot Temperature Setting
1. Press and hold the up arrow button for 3 seconds until the hot water button starts to blink and the current hot
water temperature appears on the display.
2. Use the up and down arrow buttons to scroll to your desired hot water temperature. The range is 174˚F to 194˚F
(79˚C to 90˚C).
3. Press the lock button when nished. The temperature stops blinking and the time is displayed.
Dispense Cold or Room Temperature Water
NOTE: Water will take approximately 1 hour after plugging in and turning on to become completely chilled.
1. Place a drinking glass or container under the tap and press the cold water button to dispense cold water or the
ambient water button to dispense room temperature water.
2. Release the button when your container is full.
To Next Page
Loading...
Need help?
General
