12
Cleaning and Maintenance
This dispenser runs on a continuous UV cleaning cycle.
It works for 40 minutes (UV icon on the display is on), turns o for 140
minutes, and then cycles back on again as long as the dispenser is
plugged in and on.
Task Frequency Instruction
Sanitizing Every 3 months
Use a disinfectant, purchased separately, following directions
from manufacturer for proper amount to use. Use the Cleaning
the Dispenser directions when sanitizing.
Removing
minerals
deposits
Every 6 months
Mix 4 liters water with 200g citric acid crystals, inject into the
machine and make sure the water can flow out of the hot
water tap. Switch on the power and allow it to heat for about
10 minutes. After 30 minutes, drain the liquid and clean it with
water, dispensing two or three times.
Filter Replacement Schedule
Filter Type Replacement Schedule Function
Pre-Carbon 6 months or 950 gallons
Reduces chlorine, taste and odor, lead
and cysts.
Sediment 6 months or 950 gallons
Performs a coarse filtration of original
water. Removes mud, sand, iron, rust,
and suspensions, and impurities.
Post-Carbon 6 months or 950 gallons Taste and impurity removal.
Replace the Filters
IMPORTANT: Only replace the filters with new filters designed for this dispenser. Any other type of filter will
damage the machine and void any warranty.
When a filter is approaching the end of its life, the change filter icon on the display turns on. To change filters:
1. Shut off the water supply.
2. Remove the old lters and replace with new lters. Ensure the sediment lter is on the left and the carbon block
lter is on the right.
3. To ush your new lters, follow the instructions in Step 5 ‑ Flush the Filters and Complete the Installation.
4. Hold the lter reset switch on the back of the unit for 3 seconds until the lter life reminder lightis off.
To Next Page
Loading...
Need help?
General
