13
Filter Specifications
Sediment Filter Pre-Carbon Filter
(Sediment, Dirt, and Rust Removal) (Taste and Impurity Removal)
Filter Capacity
950 Gallons
Filter Capacity
950 Gallons
Flow Rate
0.8 GPM
Flow Rate
0.8 GPM
Suggested PSI
14.5 - 58 psi
Suggested PSI
14.5 - 58 psi
Temperature
33 - 100 °F
Temperature
33 - 100 °F
Post-Carbon Filter
(Taste and Impurity Removal)
Filter Capacity
950 Gallons
Flow Rate
0.8 GPM
Suggested PSI
14.5 - 58 psi
Temperature
33 - 100 °F
Care and Maintenance
• Keep this dispenser in a dry and cool place and avoid direct sunshine.
• Ensure the back of the dispenser is at least 20 cm (8 in.) away from the wall.
• Never put the dispenser on paper or foam, which may store water and then cause creepage. Never put anything
flammable beside this machine.
• Do not use the dispenser outdoors or in a place that can be splashed by water.
• If the dispenser is not in use for longer than a 24-hour period, turn o the heating switch or the refrigerating
switch to save power and drain any remaining water.
• If the water supply is cut o, shut o the water supply and turn the dispenser o. When the water supply is back
on, re-open the water supply to the dispenser, turn the dispenser on, and allow the dispenser to run in order to
discharge sediment.
To Next Page
Loading...
Need help?
General
