6
Package Contents
A
B
G
C
D FE
H
Part Description Quantity Part Description Quantity
A Filter flushing tube 1 E Pre-carbon filter 1
B Shut-o valve tube (7 ft.) 1 F Post carbon filter 1
C
Filter housing
(for filter flushing)
1 G
Feed water adapter
(with extra nut)
1
D Sediment filter 1 H Plumber’s tape 1
Materials Needed
Wrench
Installation
1. Determine Installation Location
A. Place the dispenser upright.
B. Locate the dispenser on a hard and level surface in a cool shaded
location near a grounded wall outlet.
NOTICE: Do NOT plug in the power cord until the entire installation
section is completed.
C. Position the back of the dispenser no closer than 20 cm (8 in.) from a
wall and permit free airow between the wall and water dispenser.
To Next Page
Loading...
