Model 871A User’s Manual USING THE LASER WAVELENGTH METER
Bristol Instruments, Inc. 20
Select the radio button for the Logging Interval. When “Measurement” is
selected, the number of measurements can be adjusted incrementally using
the up/down arrows or by highlighting the current measurement interval and
entering a new measurement interval with the keyboard. When “Time” is
selected, the time can be adjusted incrementally using the up/down arrows or
by highlighting the current time duration and entering a new time interval with
the keyboard. Check the boxes next to each measurement parameter you
wish to track. Click Start to begin the logging of wavelength data.
• Stop Data Logging – Stops the current logging operation. Note that if you
started logging using the “Stop after measurements” or “Stop after hours,
minutes, seconds” options, logging will stop automatically and you do not need to
click on Stop Data Logging unless you wish to abort early. In either case, the
logging data will be written to the specified file when data logging is stopped.
• Load Settings – Opens a previously saved Settings file from a text-based
initialization (*.ini) format file. These files can be used to quickly configure the
NuView software for different users or experimental setups. Click on Load
Settings, browse to find the desired settings file, select it, and click on Open to
load the Settings file.
To Next Page
Loading...
