Brivo IPDC - Page 54

54
© 2020 Brivo Systems LLC. All rights reserved. P-MAN-PUB-Panel Networking Guide
Panel Networking Guide
Event Rate Control
The Event Rate Control page allows the administrator to limit the number of notications reported for Tamper
events, Wiring (Input/Output) events, and Unauthorized IP Access Events within a dened period of time.
1. Click Hardware to access the Hardware menu bar.
2. Click Event Rate Control to access the Event Rate Control page.
3. To limit Tamper event notications, check the Tamper Event rate control checkbox.
4. Enter the maximum number of event pairs (Open/Closed) and the number of hours (the default for each is
one).
5. To limit Wiring (Input/Output) event notications, check the Wiring (Input IO) Event rate control checkbox.
6. Enter the maximum number of event(s) and the number of hours (the default for each is one).
7. To limit Unauthorized IP Access Event notications, check the Unauthorized IP Access Event rate control
checkbox.
8. Enter the maximum number of event(s) and the number of hours (the default for each is one).
9. Click Apply to complete the process.
Figure 56: Event Rate Control