Broadcom Brocade G720 - Attaching the Extension Brackets to the Device

G720-Install-IG101 Installation Guide Brocade
®
G720 Switch Hardware Installation Guide
Attaching the Extension Brackets to the Device
Complete the following steps to attach the extension brackets to the device. You can use medium and long extension
brackets for this task.
1. Select the proper length extension bracket for your rack depth.
2. Position the right extension bracket along the side of the device as shown in the figure.
3. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket extension and then into
the holes on the side of the device. Use the upper and lower screw holes, leaving the center holes empty.
4. Repeat Steps 2 and 3 to attach the left extension bracket to the left side of the device.
5. Tighten all 8-32 x 5/16-in. screws to a torque of 17 cm-kg (15 in.-lb).
Figure 5: Attaching the Extension Brackets to the Device
1. Extension Bracket
2. Screws, 8-32 x 5/16-in. Flathead Phillips
G720-Install-IG101
24
Broadcom