G720-Install-IG101 Installation Guide
Brocade
®
G720 Switch Hardware Installation Guide
Attaching the Rear Brackets to the Extensions
Complete the following steps to attach the rear brackets to the extensions. You can use short or long rear brackets for this
task, depending on the depth of your rack.
1. Select the proper length rear bracket for your rack depth.
2. Slide the right rear bracket onto the right extension bracket, as shown in the figure.
3. Attach the brackets using four 6-32 x 1/4-in. panhead screws.
If possible, leave at least one empty vertical pair of holes between the screws for better support.
4. Repeat Step 2 and 3 to attach the left rear bracket to the left extension bracket.
5. Adjust the brackets to the rack depth and tighten all 6-32 x 1/4-in. screws to a torque of 10 cm-kg (9 in.-lb).
Figure 7: Attaching the Rear Brackets to the Extensions
1. Rear Brackets
2. Screws, 6-32 x 1/4-in. Panhead Phillips
G720-Install-IG101
26
To Next Page
Loading...
