Broadcom Brocade G720 - Parts List

G720-Install-IG101 Installation Guide Brocade
®
G720 Switch Hardware Installation Guide
You can mount the device in a two-post rack in two ways:
•
With the port side flush with the front posts
•
With the posts mounted to the mid-section of the device
Observe the following when mounting this device:
•
Two people are required to install the device in a rack. One person should hold the device, while the other while the
other screws in the front and rear brackets.
•
Before mounting your device, review any specific installation and facility requirements in the hardware installation
guide for the device.
•
Hardware devices illustrated in these procedures are for reference only and may not depict the device that you are
installing into the rack.
Time and Items Required
Allow 15 to 30 minutes to complete the installation.
The following items are required to install the device using the Universal Two-Post Rack Kit:
•
No. 2 Phillips torque screwdriver
•
1/4-in. slotted-blade torque screwdriver
Parts List
The following parts are provided with the Universal Two-Post Rack Kit (XBR-R000294):
Figure 15: Universal Two-Post Rack Kit Parts
1. Front Brackets (2)
2. Rear Brackets, 5–6-in. Post (2)
3. Rear Brackets, 3–5-in. Post (2)
G720-Install-IG101
35
Broadcom