Broadcom Brocade G720 - Introduction; About this Document; Supported Hardware and Software

G720-Install-IG101 Installation Guide Brocade
®
G720 Switch Hardware Installation Guide
Introduction
About This Document
This hardware installation guide contains procedures and safety requirements for installing the Brocade G720 Switch
into a rack system or as a stand-alone device. Also provided are steps to initially configure the switch for operation, verify
and monitor operation, replace switch field-replaceable units (FRUs), and install transceivers and cables. Complete
technical specifications for the switch are also included.
Supported Hardware and Software
The Brocade G720 Switch is introduced in the Fabric OS
®
9.0.0 release. The following tables list the power supply and
fan assemblies and the rack mount kits supported on this device.
Table 1: Power Supply and Fan Assemblies
Part Number Description Introduced (OS) Currently Supported (OS)
XBR-G350WPSAC-F 350W AC power supply with nonport-side
exhaust airflow
Fabric OS 9.0.0
Fabric OS 9.x
XBR-G350WPSAC-R 350W AC power supply with nonport-side
intake airflow
Fabric OS 9.0.0
Fabric OS 9.x
NOTE
Fabric OS 9.x refers to any supported release within the 9.x generation of Fabric OS.
Table 2: Rack Mount Kits
Part Number Description
XBR-R000294 Universal two-post mid-mount or flush-mount rack kit
XBR-R000296 Universal four-post fixed rack mount kit
The Brocade G720 Switch requires optics that are labeled with an SEC designation.
The following image provides an example of an optic label with SEC in the description (32G LW-SEC 10km).
G720-Install-IG101
7
Broadcom