Broadcom Brocade G720 - System Power LED; System Status LED

G720-Install-IG101 Installation Guide Brocade
®
G720 Switch Hardware Installation Guide
Figure 27: Brocade G720 Switch Port-Side LEDs - Right Side
1. SFP+ Upper Port 48
2. SFP+ Upper Port 50
3. SFP+ Lower Port 52
4. SFP+ Lower Port 54
5. SFP+ Upper Port 56
6. SFP+ Upper Port 58
7. SFP+ Lower Port 60
8. SFP+ Lower Port 62
System Power LED
Use the following table to interpret the system power LED.
Table 9: System Power LED Patterns during Normal Operation
LED Color Status of Hardware Recommended Action
No light The system is off, or there is an internal
power supply failure.
Verify that the system is powered on, that
the power cables are attached, and that
your power source is live.
If the system power LED is not green, the
unit may be faulty.
Contact your solution provider.
Steady green The system is on, and power supplies are
functioning properly.
No action is required.
System Status LED
Use the following table to interpret the system status LED.
G720-Install-IG101
59
Broadcom