5. Use the wire tightening screws to secure the wires.
6. Insert the DC connector with wires to the power supply and tighten the two assembly screws.
FIGURE 39 The DC wiring assembly
1 Wire tightening screws 2 Assembly screws
7. With one hand, hold the bar on the front panel of the power supply. With the other hand, support the
underside of the power supply, and insert the power supply into the empty power supply slot. Press
until the supply is completely in the slot, so that the connectors on the back of the supply are fully
engaged with the pins on the power backplane (Installing an AC power supply on page 48).
CAUTION
Carefully follow the mechanical guides on each side of the power supply slot and make sure
the power supply is properly inserted in the guides. Never insert the power supply upside
down.
NOTE
The power supply is right-side up when the manufacturer label is on the top.
8. Secure the two screws near the edges of the supply to lock the supply in place (Installing a DC
power supply).
Installation
Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide 51
53-1003823-01