Brocade Communications Systems NetIron CES 2000 Series User Manual

AC power supply
The AC power supply is shown in the following diagram.
FIGURE 48 AC power supply
Power supplies for the devices
The device ships with one alternating-current (AC) power supply or direct-current (DC) power supply. All
models have two power supply slots, enabling you to install a second power supply for redundancy. If
desired, you can install a second supply for redundancy.
If you need to install a redundant power supply, it may be easier to install it before mounting the device,
although the power supplies are "hot swappable" and can be installed or removed after the device is
mounted and powered on. Brocade recommends that you disconnect the power supply from AC power
before installing or removing the supply.
CAUTION
Changes or modifications made to this device that are not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Removing the AC power supply
AC power supply
Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide 81
53-1003823-01

Brocade Communications Systems NetIron CES 2000 Series Specifications

General

Brand	Brocade Communications Systems
Model	NetIron CES 2000 Series
Category	Switch
Language	English