Operation & Installation Manual RFS1 V2
MA365 Rev 3
21 of 46
and rectified before the locate timer times out, the locate function can be cancelled
by pressing the button once again.
The locate facility acts as a service tool to identify contaminated or faulty Smoke or
Heat Alarms.
3.6.2.3 Alarm Mute
When the “Locate” button is pressed, the locate LED turns to steady and the “Mute”
LED starts flashing to prompt the occupant to the next course of actions. Once the
alarm has been located, pressing the “Mute” button will silence the active
Smoke/Heat Alarms for approximately 10 minutes. The mute function deactivates all
devices on the alarm circuit (Smoke / Heat Alarm sounders, strobes, vibration pad,
etc). Pressing the “Mute” button once starts the mute timer for approximately 10
minutes. To cancel the timing sequence, press the button once again. The mute
function will automatically reset after the 10 minutes timer.
3.6.2.4 Test Button
The “Test” function allows the occupant to test the RFS1 V2 system. Pressing the
“Test” button once, activates all Smoke/Heat Alarms, panel sounder, strobes,
vibration pads, etc. Pressing the button once again will cancel the test mode.
Note: When the “Test” button is pressed, the alarm relay remains in normal mode.
To Next Page
Loading...