Operation & Installation Manual RFS1 V2
MA365 Rev 3
33 of 46
A properly designed and installed detection system offers effective life and property
protection; however, for ongoing reliability the system must be maintained at its peak
performance. A poorly maintained system can lead to nuisance alarms or complete
system failure. Under these conditions the system will not perform to the level of
protection needed.
1. It is recommended that the owner test each Smoke/Heat Alarm every month
including the operation of any ancillary device.
2. It is also recommended that each 12 months a full system test be performed.
Battery and power supply voltages should be checked and adjusted, if
necessary.
To Next Page
Loading...