Brother 1034D Handbook

14
TABLE OF
CONTENTS
Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
Chapter
6
Chapter
7
Chapter
8
Chapter
9
Chapter
10
Chapter
11
Chapter
12
Chapter
13
Chapter
14
Chapter
15
Chapter
16
Chapter
17
Chapter
18
Before Threading
Preparation before
threading
Raise the telescoping thread tree to its highest
position. Make sure that the thread holders are in
alignment above the spool pins as illustrated below.
1 Thread holder on thread tree
2 Spool pin
3 On Two-needle models
4 Correct position
Antes del enhebrado
Preparación antes del
enhebrado
Levante el árbol telescópico del hilo hasta su posi-
ción más alta. Compruebe que los corchetes de hilos
quedan alineados sobre los portabobinas como se
ilustra a continuación.
1 Portahilos en el árbol del hilo
2 Portabobina
3 En los modelos de dos agujas
4 Posición correcta
CAUTION
When threading, always thread in this order:
upperlooper, lowerlooper, right needle and
then the left needle.
PRECAUCION
Cuando haga el enhebrado, enhebre siem-
pre en este orden: áncora superior, áncora
inferior, aguja derecha y luego aguja izquier-
da.
4
1
2
3

Brother 1034D Specifications

General

Type	Serger
Number of Threads	3 or 4
Stitch Length	1.0mm to 4.0mm
Differential Feed	Yes
Differential Feed Ratio	0.7 to 2.0
Maximum Sewing Speed	1, 300 stitches per minute
Color-Coded Threading	Yes
Adjustable Stitch Width	Yes
Free Arm	Yes
Thread Tension	Adjustable
Presser Foot Lifter	Yes
Built-in Thread Cutter	Yes
Free Arm Capability	Yes
Power Requirements	120V, 60Hz
Stitch Types	rolled hem
Stitch Width	5.0mm - 7.0mm (overlock), 2.0mm (rolled hem)
Needle	Standard sewing machine needles (size 11 or 14)
Included Accessories	gathering foot