EasyManuals Logo

Brother 1034D Handbook

Brother 1034D
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
23
TABLE OF
CONTENTS
Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
Chapter
6
Chapter
7
Chapter
8
Chapter
9
Chapter
10
Chapter
11
Chapter
12
Chapter
13
Chapter
14
Chapter
15
Chapter
16
Chapter
17
Chapter
18
Threading the left needle
Run the thread in the sequence illustrated, follow-
ing the yellow color and the numbers next to each
threading point.
1 Pull the thread off the spool and directly up
through the thread guide on the thread tree
from back to front.
2 Pull the thread about an extra 15cm (6
inches) through the front of the thread tree.
3 Pass the thread through the proper thread
guide.
4 Slide and hold the thread tension release
button to the right, then pass the thread
through the tension disc which is in the
channel next to the yellow tension adjust-
ment dial. Release the button.
5 Guide the thread down the channel and
across through the threading points next to
the yellow color marks following the nu-
merical order in the accompanying illustra-
tion.
6 Bring the thread down through the guide 7
above the needle and through the left
needle from front to back.
Enhebrado de la aguja
izquierda
Enhebre la aguja tal como ilustrado en la secuen-
cia, respetando el color amarillo y los números
inscritos al lado de cada punto de enhebrado.
1
Saque el hilo del carrete y póngalo direc-
tamente por la guía de enhebrado del
árbol de enhebrado desde detrás a delan-
te.
2
Tire del hilo otros 15 cm aproximadamente
por la parte delantera del árbol de enhe-
brado.
3
Pase el hilo por la guía de hilo correspon-
diente.
4
Deslice y retenga el botón de liberación de
la tensión del hilo hacia la derecha, y pase
el hilo por el disco de tensión que es el
canal situado al lado del disco de ajuste de
la tensión amarillo. Suelte el botón.
5
Guíe el hilo por el canal y pase el hilo a
través de los puntos de enhebrado al lado
de las marcas de color amarillo siguiendo
el orden numérico de la ilustración.
6
Baje el hilo por la guía 7 por encima de la
aguja y por la aguja izquierda desde de-
lante a atrás.

Table of Contents

Other manuals for Brother 1034D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brother 1034D and is the answer not in the manual?

Brother 1034D Specifications

General IconGeneral
TypeSerger
Number of Threads3 or 4
Stitch Length1.0mm to 4.0mm
Differential FeedYes
Differential Feed Ratio0.7 to 2.0
Maximum Sewing Speed1, 300 stitches per minute
Color-Coded ThreadingYes
Adjustable Stitch WidthYes
Free ArmYes
Thread TensionAdjustable
Presser Foot LifterYes
Built-in Thread CutterYes
Free Arm CapabilityYes
Power Requirements120V, 60Hz
Stitch Typesrolled hem
Stitch Width5.0mm - 7.0mm (overlock), 2.0mm (rolled hem)
NeedleStandard sewing machine needles (size 11 or 14)
Included Accessoriesgathering foot

Related product manuals