R - 2
Check Receiving Status
Press 9 7
then for Fax messages, press 1.
Voice messages, press
2.
1 long beep — Received message
3 short beeps — No messages
Change Receive Mode
Press 9 8
then for TAD:MSG MGR, press 1.
FAX/TEL, press
2.
FAX ONLY, press
3.
Exit Remote Retrieval
Press 9 0.
Using Remote Access Code
Dial your fax number from a telephone or
fax machine using touch tone.
When your machine answers,
immediately enter your Remote
Access Code (
3 digits followed by ).
Your machine signals the kinds of
messages it received:
1 long beep — Fax messages
2 long beeps — Voice messages
3 long beeps — Voice & Fax messages
No beeps — No messages
After 2 short beeps, enter a command.
Press
9 0 to reset the machine when
you finish.
Hang up.
MESSAGE MANAGER
REMOTE RETRIEVAL ACCESS CARD
1
2
3
4
6
5
5 1
To Next Page
Loading...
Need help?
General
