83
BAS-311E.311EL.326E.326EL
Chapter 6 Power supply and electrical parts adjustment
■ DIP switch B
B-1
B-2
B-3
B-4
B-5
B-6
B-7
B-8
When ON
Single split mode activated
----------------
Thread is not trimmed after an emergency stop.
Needle cooler output is produced. (available as an option).
When a rotating-type thread breakage detector device is used,
detection precision is changed from 8 to 14.
When a fiber-type thread breakage detector device is used, detection precision is changed from 5 to 10.
Fiber-type thread breakage detector device is ON, and DIP switch A-8 is ON (available as an option)
When using a 3-stage pedal
Feeding speed is switched to high speed.
SW No.
A-5
A-6
A-7
A-8
When ON
After sewing is completed, work clamp does not automatically rise (only in split mode).
Clamping force output is produced (Inner clamping device available as an option).
Single-pedal operation using the starting switch; when the starting switch is pressed, the work clamp
lowers, and when it is released, sewing starts.
Thread breakage detector device is activated (available as an option).
SW No.
To Next Page
Loading...
Need help?
General
