Brother BAS-326 - 2. Emblem Sewing; Emblem Sewing Procedure

2. Emblem Sewing
Sewing procedure
OT
t=2mm
Standard feed plate t = 1 mm
Presser foot F
157237-001
Apply
tape so as not to allow
the lower plate to protrude.
BAS-311· 326· 340
[Machin i ng the OT clamp plate]
1. Process the OT presser plate to the same
dimensions as the outside of the emblem to be
sewn.
* Use a punch cutter or a thread saw.
2. Make an lower plate with the same dimensions as
the feed plate.
*Process the lower plate so that its dimensions are
the
same as those of the OT presser plate which
is to be positioned above the lower plate.
[Programming]
1. Attach presser foot A before programming.
2. If the stitching is programmed so that presser foot
A can pass smoothly through the hole of the
processed OT presser plate, the seam margin will be
about2 mm.
[Sewing]
1. When using the presser foot F, set the intermittent
stroke to "0".
2. If presser foot F is used, a slight pressing can be
applied while sewing.
-5-
From the library of: Superior Sewing Machine & Supply LLC