Brother BAS-326 - 8. Basting; Basting Programming Procedure

8. Basting
Programming Procedure
(Example 1)
5
l. 999 . F
6
4
(Example 2)
7
2
11
12
6
l. 999 . F
l. 999. F
BAS-304· 311
1. Press the If] key. (The clamp will move to the
machine origin point.)
2. Use the jog key to move the clamp to the sewing
start position.
3. Program
the first stitch by pressing the IQ key.
4.
In the same way, program the second and third
stitches by pressing the [b) key. Note, however,
that movement should be made for two or more
pulses.
5. After "999" is displayed in the third stitch
position, press the 1El key, and move the needle to
the fourth stitch by pressing the jog key.
6. Program by pressing the IQ key.
7. In the same way, program the movement from
the fourth stitch to the fifth stitch, from the fifth
stitch to the sixth stitch, and from the sixth stitch
to the seventh stitch.
8. Program the eight and ninth stitches by using the
jog key and the IQ key.
9. After programming the ninth stitch, key in "111
[E)".
10 . Then, the clamp will return to the sewing start
position.
11 . Press the READ/WRITE switch to store the program
in the floppy disk.
12. Press the If] key to clear the display of the
programming machine.
-21-
From the library of: Superior Sewing Machine & Supply LLC