66
EMBROIDERY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Stopping while embroidering
If the embroidery is stopped before it is complete,
check the current needle count before turning off the
machine.
Memo
z When the machine is turned off, the
embroidery size and layout return to the
original setting.
a
Press (Start/stop button) to stop the
machine.
b
Check the current needle count on the screen
and make a note of it.
If the needle count is not displayed, press
(Settings key), and then use to display
the following screen.
• Press (Back key) to return to the embroi-
dery screen.
c
Press (Embroidery key).
X The confirmation message is displayed.
d
Press .
X The selected pattern is deleted, and the
screen for selecting the embroidery pattern
type is displayed.
e
Turn off the machine.
• Always remove the embroidery unit when
you move the machine.
f
Turn on the machine and select the pattern.
g
Press .
F-combo-BrotherE_sgml.book Page 66 Thursday, November 17, 2005 3:39 PM
To Next Page
Loading...
