Brother DCP-J515W - Basic Operations; Warning LED Indications

Chapter 1
6
Basic Operations 1
The following steps show how to change a
setting in the machine. In this example the
Paper Type setting is changed from
Plain Paper to Inkjet Paper.
a Press Menu.
b Press a or b to choose
General Setup.
Press OK.
c Press a or b to choose Paper Type .
d Press d or c to choose Inkjet Paper.
Press OK.
You can see the current setting on the
LCD:
e Press Stop/Exit.
Warning LED indications 1
The Warning LED (light emitting diode) is a
light that shows the status of the machine, as
shown in the table.
MENU
MENU
Ink Management
OK
OK
General Setup
Network
Print Reports
Select & Press
General Setup
General Setup
Paper Type Inkjet Paper
Paper Size A4
Select & Press
LCD Settings
5MinsSleep Mode
OK
LED DCP status Description
Off
Ready The DCP is ready for
use.
Orange
Cover open The cover is open. Close
the cover. (See Error
and Maintenance
messages on page 39.)
Cannot Print Replace the ink cartridge
with a new one. (See
Replacing the ink
cartridges on page 33.)
Paper error Put paper in the tray or
clear the paper jam.
Check the LCD
message. (See Error
and Maintenance
messages on page 39.)
Other
messages
Check the LCD
message. (See Error
and Maintenance
messages on page 39.)