Brother DCP-J515W - Machine Information and Resets

Troubleshooting
51
B
Machine Information B
Checking the serial number B
You can see the machine’s serial number on
the LCD.
a Press Menu.
b Press a or b to choose
Machine Info.
Press OK.
c Press a or b to choose Serial No.
Press OK.
d Press Stop/Exit.
Reset functions B
The following reset functions are available:
1 Network
You can reset the print server back to its
default factory settings such as the IP
address information.
2 All Settings
You can reset all the machine settings
back to the settings that were set at the
factory.
Brother strongly recommends you use this
operation when you dispose of the
machine.
Note
Unplug the interface cable before you
choose Network or All Settings.
(DCP-J715W only)
How to reset the machine B
a Press Menu.
b Press a or b to choose
Initial Setup.
Press OK.
c Press a or b to choose Reset.
Press OK.
d Press a or b to choose the type of reset
you want to use.
Press OK.
Press + to confirm.
e Press + to reboot the machine.