48
f Move the print head (if necessary) to
take out any paper remaining in this
area. Make sure that jammed paper is
not left in the corners of the machine (1)
and (2).
• DO NOT touch the encoder strip (1).
Doing this may cause damage to the
machine.
• If the print head is in the right corner as
shown in the illustration (2), you cannot
move it. Re-connect the power cord. Hold
down Stop/Exit until the print head moves
to the centre. Then unplug the machine
from the power source and take out the
paper.
• If the paper is jammed under the print
head, unplug the machine from the power
source, and then move the print head to
take out the paper.
Hold the concave areas with the triangle
marks shown in the illustration (3) to move
the print head.
• If ink gets onto your skin, immediately
wash with soap and plenty of water.
1
3
2
To Next Page
Loading...
