Brother HL-2030 - Page 104

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
Confidential
4-12
NOTE:
When re-assembling the chute base, check that the bind B M4x12 taptite screws (A) and
(B) shown in the figure above are secured correctly.
<How to check>
Take the Drum/Toner Unit out from the printer. Check that the distance between the floor
and the separation roller collar of the pickup roller holder ASSY is 45.5 to 47.5mm by
using the plate jig. If not, re-assemble the chute base.
B
A
47.5mm
Morethan 47.5mm
45.5mm
Lessthan
45.5mm
Fig. 4-18
Separation roller collar
Floor
Plate jig
Pickup roller holder ASSY
(Separation roller)
45.5 to 47.5mm
[A] is contacted with the roller.
[B] is not contacted with the roller.
45.5mm
47.5mm
Pickup roller holder ASSY
(Separation roller)
Plate jig
<Plate jig>