Brother HL-2030 - Page 118

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
Confidential
4-26
(6) Remove the pan (S/P washer) M3.5x6 screw, and then remove the ground wire.
(7) Remove the bind B M4x12, taptite screw, and then remove the LV shield plate.
Fig. 4-43
(8) Remove the two flat S M3x8, taptite screws, and then remove the inlet harness ASSY.
Fig. 4-44
LV shield plate
Screws, pan (S/P washer)
M3.5x6
Ground wire
Main frame R
Taptite, bind B M4x12
Inlet harness ASSY
Taptite, flat S M3x8
LV shield plate
Main frame R