2-22
Confidential
Error
Codes
Description
Refer
to:
Error
Codes
Description
Refer
to:
8A01
The registration rear sensor detected
that the paper fed was smaller or larger
than the specified size in duplex
printing mode.
2-61
9203 ---
8A02 --- 9204 ---
8B01 --- 9205 ---
8C00
There is no paper set in the manual feed
slot on the manual feed slot printing.
2-61 9206 ---
8D01 --- 9301
When paper was fed from the MP tray,
the MP paper empty sensor detected
that no paper was in the MP tray.
2-63
8D02 --- 9302
When paper was fed from the paper
tray, the T1 paper empty sensor or T1
paper feed sensor detected that no
paper was in the paper tray.
2-63
8E01
Paper size is not set as A4/Letter/
Legal/Folio when receiving fax or
printing a list/report.
2-62 9303 ---
8E02
Detected that the size of paper set in the
paper tray was over 10 mm shorter than
paper size set in the machine during
faxing or printing a list or report.
2-62 9304 ---
8F01 --- 9305 ---
8F02 --- 9306 ---
8F03 --- 9309
Detected that there was no paper set
in all trays when TrayAuto was
selected for printing.
2-64
9001
The size of paper loaded in the MP
tray and the one specified from the
driver are not same when paper is fed
from the MP tray.
2-62 930A
Paper ran out during Fax / List
continuous printing.
9002
The size of paper loaded in the paper
tray and the one specified from the
driver are not same when paper is fed
from the paper tray.
2-62
9501 ---
9003 --- 9502 ---
9004 --- 9503 ---
9005 --- 9504 ---
9006 --- 9505 ---
9102 --- 9601 ---
9103 --- 9608 ---
9104 --- 9701
For 2-sided printing, paper size setting of
the printer driver that was not supported
by 2-sided printing was selected.
2-64
9105 --- 9702
For printing by feeding paper from the
paper tray, the size of paper specified
from the driver set the size which was
not supported by the paper tray.
2-64
9200 --- 9703 ---
9201
When printing from the MP tray, paper
type setting in the machine does not
match the setting in the driver.
2-62 9704 ---
9202
When printing from the paper tray,
paper type setting in the machine does
not match the setting in the driver.
2-62 9705 ---
To Next Page
Loading...
Need help?
General
