Brother MFC-7290 - Mode Timer; Dial Prefix; Setting up the Prefix Number

General Setup
5
1
Mode Timer 1
The machine has two or three mode keys on
the control panel: FAX, SCAN (for FAX-2950,
MFC-7240 and MFC-7290) and COPY.
You can set how much time the machine
takes after the last Copy or Scan operation to
return to FAX mode default. If you choose
Off, the machine will stay in the mode you
used last.
FAX-2950, MFC-7240 and MFC-7290
1
FAX-2840 1
a Press Menu, 1, 1.
General Setup
1.Mode Timer
b Press a or b to choose 0 Sec, 30
Secs, 1 Min, 2 Mins, 5 Mins or Off.
Press OK.
c Press Stop/Exit.
Dial Prefix 1
The Dial Prefix setting will automatically dial a
predefined number before every fax number
you dial. For example: If your telephone
system requires a 9 to dial an outside number
use this setting to automatically dial 9 for
every fax you send.
Setting up the prefix number 1
a Press Menu, 0, 6.
(For New Zealand) Press Menu, 0, 5.
b Enter the prefix number (up to 5 digits)
on the dial pad.
Press OK.
Note
• You can use the numbers 0 to 9, #, l
and !. (Press Hook/Hold to display “!”.)
You cannot use ! with any other numbers
or characters.
If your telephone system requires a timed
break recall (hookflash), press Hook/Hold
to enter the break.
• (Not available in New Zealand) If the pulse
dialing mode is on, # and l are not
available to use.
c Press Stop/Exit.