Brother MFC-7290 - Enlarging or Reducing the Image Copied

Chapter 7
38
f Press Start.
To change the default setting follow the steps
below:
a Press Menu, 3, 3.
b Press d or c to increase or decrease the
contrast.
Press OK.
c Press Stop/Exit.
Brightness 7
Adjust the copy brightness to make copies
darker or lighter.
To temporarily change the copy
brightness setting, follow the steps
below:
a Make sure you are in COPY mode
.
b Load your document.
c Use the dial pad to enter the number of
copies (up to 99).
d Press Options.
Press a or b to choose Brightness.
Press OK.
e Press d or c to make a lighter copy or a
darker copy.
Press OK.
f Press Start.
To change the default setting follow the
steps below:
a Press Menu, 3, 2.
b Press d or c to make a lighter copy or a
darker copy.
Press OK.
c Press Stop/Exit.
Enlarging or reducing the
image copied 7
You can choose the enlargement or reduction
ratios.
Auto sets the machine to calculate the
reduction ratio that best fits the size of paper.
Custom(25-400%) allows you to enter a
ratio from 25% to 400% in 1% increments.
To enlarge or reduce the next copy follow the
instructions below:
a Make sure you are in COPY mode
.
b Load your document.
c Use the dial pad to enter the number of
copies (up to 99).
d Press Options.
Press a or b to choose
Enlarge/Reduce.
Press OK.
e Do one of the following:
 Press a or b to choose the
enlargement or reduction ratio you
want.
Press OK.
 Press a or b to choose
Custom(25-400%).
Press OK.
Use the dial pad to enter an
enlargement or reduction ratio from
25% to 400%. (For example, press
53 to enter 53%.)
Press OK.
f Press Start.