Brother MFC-8380DN - Page 144

134
Duplex Disabled The duplex tray is not installed
properly.
Remove the duplex tray and install it again.
Fuser Error The temperature of fuser unit
does not rise at a specified
temperature within specified time.
Turn the power switch off, wait a few
seconds, and then turn it on again. Leave the
machine for 15 minutes with the power on.
The machine can be turned off for up to
60 hours without losing faxes stored in the
memory. (See Transferring your faxes or Fax
Journal report on page 137.)
The fuser unit is too hot.
Jam Duplex The paper is jammed in the
duplex tray.
(See Paper jams on page 139.)
Jam Inside The paper is jammed inside the
machine.
(See Paper jams on page 139.)
Jam MP Tray The paper is jammed in the MP
tray of the machine.
(See Paper jams on page 139.)
Jam Rear The paper is jammed in the back
of the machine.
(See Paper jams on page 139.)
Jam Tray 1
Jam Tray 2
(MFC-8380DN)
The paper is jammed in the paper
tray of the machine.
(See Paper jams on page 139.)
No Paper The machine is out of paper or
paper is not correctly loaded in
the paper tray.
Do one of the following:
 Refill the paper in the paper tray or MP
tray.
 Remove the paper and load it again.
No Response/Busy The number you dialled does not
answer or is busy.
Verify the number and try again.
No Toner The toner cartridge or the drum
unit and toner cartridge assembly
is not installed properly.
Re-install the toner cartridge or the drum unit
and toner cartridge assembly.
No Tray The paper tray is not completely
closed.
Close the paper tray properly.
Error Message Cause Action