Brother MFC-9320CW - Page 341

5-126
Confidential
Fig. 5-146
(5) Remove the LED ASSY from the Holder.
(6) Remove the other LED ASSYs in the same way as procedures (3) to (5) above.
Fig. 5-147
Assembling Note:
- When you assemble the Holder hook, make sure to insert the Hook A of the Holder hook
into the “A” of the LED ASSY first, and then assemble the Hook B of the Holder hook to
the Holder.
- After assembling, make sure to check that the Hook A is firmly engaged to the Holder.
If it is not engaged to the Holder firmly, it might cause an image failure.
LED ASSY
Holder hook
LED ASSY
Holder hook
Holder hook
Holder
Holder
Holder
Hook A
“A"
Holder hook
Hook B
Hook A
Hook B
a
b
c
Sub frame ASSY
LED ASSY
Holder