Security features
100
Sending an E-mail with user authentication 7
This machine supports POP before SMTP and SMTP-AUTH methods to send an E-mail via an E-mail server
that requires user authentication. These methods prevent an unauthorized user from accessing the E-mail
server. You can use Web Based Management or BRAdmin Professional 3 to configure these settings. You
can use POP before SMTP and SMTP-AUTH methods for E-mail Notification, E-mail reports and Internet fax
sending.
E-mail server settings
You need to match the settings of SMTP authentication method with the method used by your E-mail server.
Contact your network administrator or your ISP (Internet Service Provider) about the E-mail server
configuration.
You will also need to check SMTP-AUTH of SMTP Server Authentication Method to enable the SMTP
server authentication.
SMTP settings
You can change the SMTP port number using Web Based Management. This is useful if your ISP (Internet
Service Provider) implements the “Outbound Port 25 Blocking (OP25B)” service.
By changing the SMTP port number to a specific number which your ISP is using for the SMTP server (for
example, port 587), you would then be able to send an E-mail via the SMTP server.
If you can use both POP before SMTP and SMTP-AUTH, we recommend choosing SMTP-AUTH.
If you choose POP before SMTP for the SMTP Server Authentication Method, you need to configure the
POP3 settings. You can also use the APOP method if needed.
To Next Page
Loading...
Need help?
Printing Specifications
