Setting Up the Machine
6
STEP 1
2 While pressing the green paper-guide release
lever (1), slide the paper guides to fit the paper
size. Make sure that the guides are firmly in the
slots.
3 Fan the stack of paper well to avoid paper jams
and misfeeds.
4 Put paper in the paper tray. Make sure that the
paper is flat in the tray and below the maximum
paper mark.
5 Put the paper tray firmly back into the machine.
4 Install the power cord and
phone line
1 Make sure that the machine’s power switch is
off. Remove the label covering the AC power
inlet.
2 Connect the AC power cord to the machine.
3 Plug the AC power cord into an AC outlet. Turn
the power switch on.
4 Connect one end of the telephone line cord to
the jack on the machine marked LINE and the
other end to a modular wall jack.
Note
Make sure the telephone line cord is connected to
the jack labeled LINE and not the EXT. jack.
(1)
To Next Page
Loading...
