Brother MFC-9460CDN - Auto Registration; Manual Registration

Routine maintenance
73
A
Note
• If an error message is displayed, press
Black Start or Color Start and try again.
(For more information, see Error and
maintenance messages in Appendix B of
the Basic User's Guide.)
• If you print using the Windows
®
printer
driver, the driver will get the calibration
data automatically if both
Use Calibration Data and
Get Device Data Automatically are on.
The default settings are on. (See
Advanced tab in the Software User's
Guide.)
• If you print using the Macintosh printer
driver, you need to perform the calibration
using the Status Monitor. After turning
the Status Monitor on, choose Color
Calibration from the Control menu. (See
Status Monitor in the Software User's
Guide. When the Status Monitor is open,
choose Control / Color Calibration from
the menu bar.)
Auto Registration A
Registration A
If solid areas of color or images have cyan,
magenta or yellow fringes, you can use the
auto-registration feature to correct the
problem.
a Press Menu, 4, 7.
b To start, press 1.
To exit, press 2.
c Press Stop/Exit.
Manual Registration A
If color still appears incorrectly after auto-
registration, you will need to perform manual
registration.
a Press Menu, 4, 8, 1.
b Press Black Start or Color Start to
start printing the color registration chart.
c When the machine has finished printing
the registration chart, press 2
(Set Regist.) to correct the color
manually.
d Starting at 1 (1 Magenta Left) on the
chart, check which colored bar has the
most uniform print density and enter its
number into the machine using the
a and b keys.
Press OK.
Repeat for 2 (2 Cyan Left), 3
(3 Yellow Left), 4, 5, 6 to 9.
e Press Stop/Exit.