Brother MFC-9465CDN - Setting the Password for the Administrator; Changing the Password for the Administrator; Setting up the Public User Mode

Security features
5
2
Setting the password for the
administrator 2
The password you set in these steps is for the
administrator. This password is used to set
up users and to turn Secure Function Lock on
or off. (See Setting up restricted users
on page 6 and Turning Secure Function Lock
on/off on page 6.)
a Press Menu, 1, 7, 1.
b Enter a four-digit number for the
password using numbers 0-9.
Press OK.
c Re-enter the password when the LCD
shows Verify:.
Press OK.
d Press Stop/Exit.
Changing the password for
the administrator 2
a Press Menu, 1, 7, 1.
b Press a or b to choose Set Password.
Press OK.
c Enter the registered four-digit password.
Press OK.
d Enter a four-digit number for the new
password.
Press OK.
e If the LCD shows Verify: re-enter the
new password.
Press OK.
f Press Stop/Exit.
Setting up the public user
mode 2
Public user mode restricts the functions that
are available for Public users. Public users do
not need to enter a password to access the
features made available through this setting.
You can set up one Public user.
a Press Menu, 1, 7, 1.
b Press a or b to choose Setup ID.
Press OK.
c Enter the administrator password.
Press OK.
d Press a or b to choose Public.
Press OK.
e Press a or b to choose Enable or
Disable for Fax Tx.
Press OK.
After you have set Fax Tx, repeat this
step for Fax Rx, Copy, Scan,
USB Direct, PC Print and
Color Print. When the LCD shows
Exit, press OK.
f Press Stop/Exit.
Downloaded from ManualsPrinter.com Manuals