Brother MFC-9465CDN - Tray Selection; Duplex (2-Sided) Copying; Duplex Copy (Long Edge Flip)

Making copies
47
7
g Press Mono Start or Colour Start. The
machine scans the other side of the card
and prints the page.
Note
When 2 in 1 ID Copy is chosen, the
machine sets the quality to Photo and the
contrast to +2 (-nnnno+).
Tray selection 7
You can change the Tray Use only for the
next copy.
a Make sure you are in Copy mode .
b Load your document.
c Use the dial pad to enter the number of
copies (up to 99).
d Press Options. Press a or b to choose
Tray Select. Press OK.
e Press d or c to choose the MP>T1,
M>T1>T2
1
, T1>MP, T1>T2>M
1
,
#1(XXX)
2
, #2(XXX)
12
or MP(XXX)
2
.
1
T2 and #2 appears only if the optional lower
tray is installed.
2
XXX is the paper size you set in Menu, 1, 2, 2.
f Press Mono Start or Colour Start.
Note
To change the default setting for Tray
Select, see Tray Use in copy mode in
Chapter 2 of the Basic User's Guide.
Duplex (2-sided)
copying 7
If you want to use the automatic duplex copy
feature, load your document in the ADF.
If you get an Out of Memory message while
you are making duplex copies, try installing
extra memory. (See Installing extra memory
on page 61.)
Duplex Copy (long edge flip) 7
MFC-9460CDN
 1sidedi 2sidedL
Portrait
Landscape
a Make sure you are in Copy mode .
b Load your document.
c Enter the number of copies (up to 99)
using the dial pad.
d Press Duplex and a or b to select
1sidedi2sided L.
Press OK.
e Press Mono Start or Colour Start to
copy the document.
1
2
1
1
2
1
1
2
1
2
Downloaded from ManualsPrinter.com Manuals