Brother MFC-9465CDN - Page 50

Chapter 7
44
Brightness 7
Adjust the copy brightness to make copies
darker or lighter.
To temporarily change the copy brightness
setting, follow the steps below:
a Make sure you are in Copy mode .
b Load your document.
c Use the dial pad to enter the number of
copies (up to 99).
d Press Options.
Press a or b to choose Brightness.
Press OK.
e Press d or c to make a lighter copy or a
darker copy.
Press OK.
f Press Mono Start or Colour Start.
To change the default setting follow the steps
below:
a Press Menu, 3, 2.
b Press d or c to make a lighter copy or a
darker copy.
Press OK.
c Press Stop/Exit.
Colour Adjust (Saturation) 7
You can change the default setting for colour
saturation.
To change the default setting follow the steps
below:
a Press Menu, 3, 4.
b Press a or b to choose 1.Red,
2.Green, or 3.Blue.
Press OK.
c Press d or c to increase or decrease the
colour saturation.
Press OK.
d Return to step b to choose the next
colour. Or press Stop/Exit.
Downloaded from ManualsPrinter.com Manuals